Location
Mckinney, TX | United States
Job description
Scope of Work:
- Install 99 MIMO style antennas throughout 2 buildings.
- Run (2) coax lines per antenna.
- Install directional splitters, as shown in site drawings. This will require small structures to support the splitters and safely route the cabling above finished ceilings.
- Install fire-resistant backboards with the MDF and remote location at the Coaching Center.
- Use JMA compression tools for all coax connections. This project will have the following connector types, requiring different dyes ( 4.3.10/ 7-10 Din-M / N-Male) all should be provided.
- Build out existing racks inside the MDF room. Installation of (6) Nokia radios on rack 1 will require support struts.
- Install remote with the coaching center. Exact location TBD.
- Make all necessary penetrations, sealing them daily. Penetration sleeve type not clarified.
- Support all coax runs at 5ft intervals unless existing tray is in place and permitted to use.
- Ground all installed equipment inside MDF to the ground bar. ONLY 2 hole lugs are acceptable.
- PIM and sweep test all coax runs. Premade jumpers will not require testing. (GC must hold onto those test results)
- Provide various mounting solutions for omni antennas.
- If core holes are required, obtain approval before making holes.
- Provide all ancillary material (e.g., tie wraps, backboards, Velcro, screws, nuts, etc).
- Determine the conduit run between the two buildings.
Deliverables:
- Daily emailed update reports.
- Coax pull sheets.
- Pictures of splitters and antennas uploaded into TI.
- Cable PIM and sweep results uploaded to TI.
- Red line drawings of cabling changes.
- Closeout package once the project is complete.
Job tags
Salary
